Info: +36-30/6701767 (H-P.: 8-18 óráig!)
A Plinius közel 40 év tapasztalattal rendelkezik High End erősítők fejlesztésében, amit az erősítők által nyert számos nívós elismerés is tükröz. A Plinius Reference M-10 (RM-10) high end előerősítő valóban egy csúcskategóriás előerősítő, ami kifinomult hangjának és gyönyörű vonalvezetésének köszönhetően mindenképpen kerüljön fel a bakancslistára high end előerősítő vásárlásakor.
Általános információk:
Plinius Reference M-10 (RM-10) high end előerősítő tulajdonságai:
Reference M-10 Preamplifer
Everything about the Reference M-10 preamplifier demonstrates Plinius’ relentless quest for designs that reveal all the detail in your music, delivered in sophisticated styling that gets your attention.
Years of experience and constant striving for excellence in our electronics designs have resulted in something special with this dual mono design. Lovers of high end audio reproduction will be impressed with the RM10’s uninhibited ability of supplying pure detail to the matching Reference A-300 power amplifier.
The ‘Reference’ aesthetic retains enough of Plinius’ distinctive styling to remind you of its origins but makes a new statement that these pieces demonstrate continuing evolution in our drive to deliver the whole experience of being immersed in music.
FREQUENCY RESPONSE20Hz to 20kHz +/–0.1dB
DISTORTION<0.001% THD+N
INPUT7V RMS RCA/Unbalanced, 7V RMS XLR/Balanced
INPUT IMPEDENCE7.5k ohms RCA/Unbalanced, 47k ohms XLR/Balanced
PRE OUT SOURCE IMPEDENCE10 ohms RCA/Unbalanced, 20 ohms XLR/Balanced
MAXIMUM OUTPUT LEVEL7V RMS RCA/Unbalanced, 14V RMS XLR/Balanced
DIMENSIONSHeight: 170mm (6.75")Width: 510mm 20")Depth: 480mm (19")Weight: 16kg (35lbs)
Line OutThe Line out provides a line level output, carrying the selected source signal. The Line Out allows for the signal to go on to recording equipment, headphone amplifiers or sub-woofer speakers.
Remote Trigger Input and OutputIn order to integrate more effectively into a home theatre system, the Reference M-10 has a remote trigger input socket on the rear panel. By connecting a processor or source component with a remote trigger signal to this socket, the Reference M-10 can be switched between HT Bypass and standby modes. When in standby the preamplifier draws less current and will operate at minimum temperature. This may be of advantage in multi-amplifier and/or remote installations.The Reference M-10 also features two remote trigger output sockets. By connecting this trigger output to other system components, the entire system can be put in and out of standby by the source component.
Ground Lift SwitchThis allows for the signal ground to be isolated from the main chassis earth. This can assist in resolving unwanted ground loops or hum due to duplicate ground paths in some systems.
WBT and Neutrik connectorsHigh quality WBT RCA and Neutrik XLR input and Output connectors are fitted to ensure a high performance, low distortion interface between your cables and the preamplifier.
Balance ControlThe balance control adjusts the volume level between left and right. This can assist with equalising channel balance where a recording or speaker placement is not optimal.
Gain SwitchThe gain switch allows adjustment of the Lineamp amplification factor. High gain offers a similar level to most preamplifiers, while low gain allows further improvement in distortion levels and can assist where multiple instances of XLR connections result in too much gain in the complete system.
Aluminium ConstructionThe aluminium lid and panels provide a non-magnetic cover to reduce unwanted magnetic fields that can interfere with the sensitive audio signals.
